Dell PowerEdge T105 Hardware Owner's Manual (PDF) - Page 79
Microprocessor, Removing the Processor
View all Dell PowerEdge T105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
8 Reconnect the system to the electrical outlet, and turn on the system and attached peripherals. The system detects that the new memory does not match the existing configuration information and generates the following message: The amount of system memory has changed. Strike the F1 key to continue, F2 to run the setup utility 9 Press to enter the System Setup program and check the value for Memory Information. See "System Setup Options" on page 33. The system should have changed the value for Memory Information to reflect the newly installed memory. Verify the new value. If it is correct, skip to step 13. 10 If the memory value is incorrect, turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 11 Open the system. See "Opening the System" on page 47. 12 Ensure that the installed memory modules are seated properly in their connectors, and repeat step 7 through step 9. 13 When the Memory Information value is correct, press to exit the System Setup program. 14 Run the system diagnostics to verify that the memory modules are operating properly. See "Running the System Diagnostics" on page 128. Microprocessor You can upgrade the system processor to take advantage of future options in speed and functionality. The processor and its associated internal cache memory are contained in a 939-pin micro pin grid array (PGA) package. Removing the Processor CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge. Installing System Components 79