Dell PowerEdge T105 Hardware Owner's Manual (PDF) - Page 84
Removing the Cooling Fans, attaches the fan to the chassis bracket mount.
View all Dell PowerEdge T105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Removing the Cooling Fans CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 47. 3 Disconnect the fan's power cable from the system board. 4 If you are removing the smaller hard drive cooling fan (see Figure 3-23): a Squeeze the two release tabs together at the top of the fan cage that attaches the fan to the chassis bracket mount. b Lift the fan out. NOTE: The SAS hard drive cooling fan is present only if a SAS 6i/R integrated controller card is installed. 5 If you are removing the larger processor cooling fan: a Remove the heat sink and shroud assembly. See "Removing the Processor" on page 79. Do not remove the processor, however. b Press the side release tab that attaches the processor cooling fan to the chassis (see Figure 3-24). c Press the bottom release tab and shift it forward to maneuver the bottom securing tabs out of their mounting holes (see Figure 3-24). d Slide the fan toward the back panel and lift the fan out. 84 Installing System Components