Dell PowerEdge T105 Hardware Owner's Manual (PDF) - Page 65
by pulling up on the blue tab.
View all Dell PowerEdge T105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
3 Disconnect the hard drive power cable from the hard drive that you are removing. 4 Disconnect the blue data cable from the hard drive that you are removing by pulling up on the blue tab. 5 Press the blue tabs on each side of the hard-drive bracket toward each other and slide the drive and its bracket up and out of the bay. See Figure 3-14. Figure 3-14. Removing and Installing a Hard Drive in the Drive Carrier 1 2 1 hard drive power cable 2 hard drive in primary hard drive bay NOTE: If you do not intend to replace the drive, it is highly recommended that you remove the drive from the guide bracket (see Figure 3-15) and insert the empty guide bracket back into the drive bay. This eliminates the likelihood that the empty bracket will be misplaced or improperly stored while not in use. Installing System Components 65