Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 1112

distance Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax Parameters distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x). (OPTIONAL) Enter a configured prefix list name. Defaults weight = 120 Command Modes ROUTER RIP Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 pre- 6.2.1.1 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands • default-metric - assigns one distance metric to all routes learned using the redistribute command. distribute-list in Configure a filter for incoming routing updates. Syntax Parameters distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. prefix-list-name interface Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: 1112 Routing Information Protocol (RIP)