Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 1273

Related Commands • snmp-server community - sets the community string. snmp-server user Configure a new user to an SNMP group. Syntax snmp-server user name {group_name remote ip-address vrf vrf-name udp-port portnumber} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv password] [access access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name] To remove a user from the SNMP group, use the no snmp-server user name {group_name remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56 | aes128} priv password] [access access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-name] command. Parameters name group_name Enter the name of the user (not to exceed 20 characters), on the host that connects to the agent. Enter a text string (up to 20 characters long) as the name of the group. The following groups are created for mapping to read/write community/security-names (defaults): • v1v2creadu - maps to a community with ro permissions. • 1v2cwriteu - maps to a community rw permissions. remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port number on the remote device. The range is from 0 to 65535. The default is 162. vrf vrf-name Enter the keywords vrf and then the name of the VRF this is used to connect to the SNMP server. NOTE: Use this attribute to specify a VRF name that is used to connect to the remote host. If no VRF is specified, then the default VRF is used. udp-port portnumber 1 | 2c | 3 Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on the remote device. The range is from 0 to 65535. The default is 162. (OPTIONAL) Enter the security model version number (1, 2c, or 3): • 1 is the least secure version. • 3 is the most secure of the security modes. • 2c allows transmission of informs and counter 64, which allows for integers twice the width of what is normally allowed. The default is 1. encrypted auth md5 | sha (OPTIONAL) Enter the keyword encrypted to specify the password appear in encrypted format (a series of digits, masking the true characters of the string). (OPTIONAL) Enter the keyword auth to specify authentication of a packet without encryption. (OPTIONAL) Enter the keyword md5 or sha to designate the authentication level. • md5 - Message Digest Algorithm • sha - Secure Hash Algorithm auth-password priv des56 | aes128 (OPTIONAL) Enter a text string (up to 20 characters long) password that enables the agent to receive packets from the host. Minimum: eight characters long. (OPTIONAL) Enter the keywords priv to initiate a privacy authentication level setting. (OPTIONAL) Enter the keyword des56 or aes128 to specify the encryption mode. • aes128 - Use 128 bit AES algorithm in CFB mode for encryption. • des56 - Use 56 bit DES algorithm in CBC mode for encryption. Simple Network Management Protocol (SNMP) and Syslog 1273