Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 212

Version 8.3.7.0 8.5.1.0 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the S4810. Added support for 4-port 40G line cards on the E-Series. Introduced on the E-Series. Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series Introduced on the E-Series. Usage Information The ACL hit counters increment the counters for each matching rule, not just the first matching rule. Example Dell# show mac accounting access-list TestMac interface gigabitethernet 1/8 in Ingress Standard mac access-list TestMac on GigabitEthernet 1/89 Total cam count 2 seq 5 permit aa:aa:aa:aa:00:00 00:00:00:00:ff:ff count (0 packets) seq 10 deny any count (20072594 packets) Dell# Standard MAC ACL Commands When you create an access control list without any rule and then apply it to an interface, the ACL behavior reflects implicit permit. These commands configure standard MAC ACLs and support both Ingress and Egress MAC ACLs. NOTE: For more information, also refer to the Commands Common to all ACL Types and Common MAC Access List Commands sections. deny To drop packets with a the MAC address specified, configure a filter. Syntax deny {any | mac-source-address [mac-source-address-mask]} [count [byte]] [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {any | mac-source-address mac-source-address-mask} command. Parameters any mac-sourceaddress mac-sourceaddress-mask count byte log monitor Enter the keyword any to specify that all routes are subject to the filter. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to log the packets. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, see the "Flow-based Monitoring" in the Port Monitoring section in the Dell Networking OS Configuration Guide. 212 Access Control Lists (ACL)