Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 678

Version 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 pre-6.1.1.0 Description Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip route summary shown in the following example. Column Heading Description Route Source Identifies how the route is configured in Dell Networking OS. Active Routes Identifies the best route if a route is learned from two protocol sources. Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route becomes the best route. ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed. Total 1388 active... Displays the number of active and non-active routes and the memory usage of those routes. If there are no routes configured in the Dell Networking OS, this line does not appear. Example Dell> show ip route summary Route Source Active Routes Non-active Routes connected 17 0 static 3 0 ospf 100 1368 2 Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5 Total 1388 2 Total 1388 active route(s) using 222440 bytes Total 2 non-active route(s) using 128 bytes Dell> Related Commands • show ip route - display information about the routes found in the switch. show ip traffic View IP, ICMP, UDP, TCP and ARP traffic statistics. Syntax show ip traffic [all | cp | rp1 | rp2] NOTE: These options are supported only on the E-Series. Parameters all cp rp1 rp2 Command Modes EXEC Privilege (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not enter a keyword, you also view all statistics from all processors. (OPTIONAL) Enter the keyword cp to view only statistics from the Control Processor. (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1. (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2. 678 IPv4 Routing