Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 588

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. NOTE: This command also enables you to view information corresponding to a range of ports. However, for Open Networking (ON) platforms the notation for specifying port range in the command is different from how you specify in non-ON platforms. • For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want to display information corresponding to all ports between 1 and 4, specify the port range as show interfaces interface-type 1/1 - 4. • For ON platforms, you can specify multiple ports as slot/port/[subport] slot/port/[subport]. For example, if you want to display information corresponding to all ports between 1 and 4, specify the port range as show interfaces interface-type 1/1/1 - 1/1/4. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.10(0.0) 9.9(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 8.1.1.0 7.8.1.0 7.7.1.0 7.6.1.0 6.5.4.0 Introduced on the S6100-ON. Added support to display the interface configurations corresponding to a range of ports. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for 4-port 40G line cards on the E-Series. Introduced on the E-Series. Output augmented with diagnostic data for pluggable media. Removed three fields in the output: Vendor Name, Vendor OUI, and Vendor PN. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information The following describes the show interfaces transceiver command shown in the following example. Line Description Rx Power Output depends on the vendor, typically either "Average" or "OMA" (Receiver optical measurement type modulation amplitude). Temp High Alarm Factory-defined setting, typically in Centigrade. Value differs between SFPs and SFP+. threshold Voltage High Alarm threshold Displays the interface index number used by SNMP to identify the interface. 588 Interfaces