Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 207

port port destination count byte log dscp order monitor • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port parameter.) (OPTIONAL) Enter the application layer port number. Enter two port numbers if you are using the range logical operand. The range is from 0 to 65535. The following list includes some common TCP port numbers: • 23 = Telnet • 20 and 21 = FTP • 25 = SMTP • 169 = SNMP Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets the filter processes. (OPTIONAL) Enter the keyword byte to count bytes the filter processes. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. Supported on Jumbo-enabled line cards only. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. NOTE: For more information, see "Flow-based Monitoring" in the Port Monitoring section of the Dell Networking OS Configuration Guide. fragments no-drop Enter the keyword fragments to use ACLs to control packet fragments. Enter the keywords no-drop to match only the forwarded packets. Defaults Not configured Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.8(0.0) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Added the no-drop parameter. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Access Control Lists (ACL) 207