Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 991

vrf vrf-name interface (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display OSPF neighbors corresponding to that VRF. NOTE: If you do not specify this option, neighbors corresponding to the default VRF are displayed. (OPTIONAL) Enter the following keywords and the interface information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a port channel interface, enter the keywords port-channel then a number. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults Command Modes None EXEC EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 9.1.(0.0) 8.3.19.0 7.8.1.0 7.4.1.0 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced support for OSPFv3 on the S4810 and Z9000. Introduced on the S4820T. Added support for the C-Series. Introduced on the E-Series. Example Dell# show ipv6 ospf 3 neighbor gi 1/2 Neighbor ID Pri State Dead Time Interface 63.114.8.36 1 FULL/DR 00:00:38 4 Dell# ID Interface Gi 1/2 timers spf Set the time interval between when the switch receives a topology change and starts a shortest path first (SPF) calculation. Syntax Parameters Defaults timers spf delay holdtime To return to the default, use the no timers spf command. delay holdtime Enter a number as the delay. The range is from 0 to 4294967295. The default is 5 seconds. Enter a number as the hold time. The range is from 0 to 4294967295. The default is 10 seconds. • delay = 5 seconds • holdtime = 10 seconds Open Shortest Path First (OSPFv2 and OSPFv3) 991