Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 961

Intf-Down 0 Wrong-Len 0 Auth-Err 0 Version 0 No-Buffer 0 Q-OverFlow 0 Non-Dr 0 Invld-Nbr 0 MD5-Err 0 AreaMis 0 Seq-No 0 Unkown-Pkt 0 Error packets (Only for TX) Socket Errors 0 Dell# Self-Org 0 Nbr-State 0 Chksum 0 Conf-Issues 0 Socket 0 Usage Information The show ip ospf process-id statistics command displays the error packet count received on each interface as: • The hello-timer remaining value for each interface • The wait-timer remaining value for each interface • The grace-timer remaining value for each interface • The packet count received and transmitted for each neighbor • Dead timer remaining value for each neighbor • Transmit timer remaining value for each neighbor • The LSU Q length and its highest mark for each neighbor • The LSR Q length and its highest mark for each neighbor Example (Statistics) Dell(conf-if-gi-1/6)# do show ip ospf statistics Interface GigabitEthernet 1/6 Error packets (Receive statistics) Intf-Down 0 Non-Dr 0 Self-Org 0 Wrong-Len 0 Invld-Nbr 0 Nbr-State 0 Auth-Error 0 MD5-Error 0 Cksum-Err 0 Version 0 AreaMisMatch 0 Conf-Issue 0 SeqNo-Err 0 Unknown-Pkt 0 Bad-LsReq 0 RtidZero 0 Neighbor ID 4.4.4.4 Packet Statistics Hello DDiscr LSReq LSUpd LSAck RX 5 2 1 3 2 TX 6 5 1 3 3 Timers Hello 0 Wait 0 Grace 0 Dead 39 Transmit 4 Queue Statistics LSU-Q-Len 0 LSU-Q-Wmark 1 LSR-Q-Len 0 LSR-Q-Wmark 1 Dell(conf-if-gi-1/6)# Related Commands • clear ip ospf statistics - clear the packet statistics in all interfaces and neighbors. show ip ospf timers rate-limit Show the LSA currently in the queue waiting for timers to expire. Syntax Parameters show ip ospf [process-id] timers rate-limit process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults Command Modes None • EXEC • EXEC Privilege Open Shortest Path First (OSPFv2 and OSPFv3) 961