Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 965

Example Dell# conf Dell(conf)# router ospf 1 Dell(conf-router_ospf-1)# timer spf 2 5 Dell(conf-router_ospf-1)# show config ! router ospf 1 timers spf 2 5 Dell(conf-router_ospf-1)# end timers throttle lsa all Configure LSA transmit intervals. Syntax Parameters timers throttle lsa all {start-interval | hold-interval | max-interval} To return to the default, use the no timers throttle lsa command. start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. The range is from 0 to 600,000 milliseconds. Set the next interval to send the same LSA. This interval is the time between sending the same LSA after the start-interval has been attempted. The range is from 1 to 600,000 milliseconds. Set the maximum amount of time the system waits before sending the LSA. The range is from 1 to 600,000 milliseconds. Defaults • start-interval: 0 msec • hold-interval: 5000 msec • max-interval: 5000 msec Command Modes ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 9.0.2.0 8.3.11.1 8.3.8.0 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S6000.. Introduced on the Z9000. Introduced on the S4810. Usage Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached. Open Shortest Path First (OSPFv2 and OSPFv3) 965