Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 655

Version 7.5.1.0 pre-6.1.1.0 Description Introduced on the C-Series. Introduced on the E-Series. ip unreachables Enable the generation of internet control message protocol (ICMP) unreachable messages. Syntax ip unreachables To disable the generation of ICMP messages, use the no ip unreachables command. Defaults Disabled. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 pre-6.1.1.0 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. load-balance By default, for C-Series and S-Series, Dell Networking OS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port) to distribute IP traffic over members of a Port Channel as well as equal-cost paths. To designate another method to balance traffic over Port Channel members, use the load-balance command. Syntax Parameters load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | sourcedest-mac | source-mac]} | {tcp-udp | ingress-port [enable]} To return to the default setting (IP 4-tuple), use the no load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | source-dest-mac | source-mac]} | {tcp-udp | ingress-port [enable]}command. ip-selection {dest- Enter the keywords to distribute IP traffic based on the following criteria: ip | source-ip} IPv4 Routing 655