Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 1412

Version 9.5(0.1) 9.2(0.0) 9.0.2.0 9.0.0.0 8.3.19.0 8.3.12.0 Description Introduced on the Z9500. Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Introduced on the S6000. Introduced on the Z9000. Introduced on the S8420T. Introduced on the S4810. Usage Information To delay the system from bringing up the VLT port for a brief period to allow IGMP snooping and Layer 3 routing protocols to converge, use the delay-restore command. Use this command: • after a VLT device reloads. • if the peer VLT device was up at the time the VLTi link failed. Related Commands • show vlt statistics - displays statistics on VLT operations. delay-restore abort-threshold Increase the boot up timer to a value greater than 60 seconds. Syntax delay-restore abort-threshold To remove the boot up timer value, use the no delay-restore abort-threshold command. Parameters interval Enter the interval value (in seconds) for the delay restore timer to abort. The range is from 1 to 1800 seconds. The default is 60 seconds. This delay restore timer applies only during reload/boot-up and not in other scenarios (for example, during ICL flap). Defaults 60 seconds Command Modes VLT DOMAIN Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000-ON and Z9500. Usage Information To abort the VLT delay restore timer value as the maximum threshold, during reload, apply the maximum time interval to the hold-down ICL peer-up in the start-up configurations. lacp ungroup member-independent Prevent possible loop during the VLT peer switch bootup or on a device that accesses the VLT domain. Syntax lacp ungroup member-independent {vlt | port-channel} 1412 Virtual Link Trunking (VLT)