Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 575

Version 9.2(1.0) 9.0.2.0 9.2(0.2) 9.1(0.0) 8.3.12.1 8.3.11.4 8.3.11.1 8.5.1.0 8.3.7.0 8.2.1.2 8.2.1.0 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.4.1.0 6.3.1.0 Description Introduced on the Z9500. Introduced on the S6000. Added support for the tunnel interface type. Updated Management Ethernet output to include two global IPv6 addresses on S4810 and Z9000 and added output example showing OpenFlow instance ID. Updated command output to support multiple IPv6 addresses on S4810. Output expanded to support eSR4 optics in Z9000. Introduced on the Z9000. Added support for 4-port 40G line cards on the E-Series. Introduced on the S4810. Included SFP and SFP+ optics power detail in the E-Series and C-Series output. Added support for 4093 VLANs on the E-Series. Prior releases supported 2094. Introduced on the E-Series. Output expanded to include SFP+ media on the C-Series. Introduced on the S Series. Introduced on the C-Series. Changed the organization of the display output. Added the Pluggable Media Type field in the E-Series output. Usage Information Use the show interfaces command for details on a specific interface. NOTE: In the CLI output, the power value is rounded to a 3-digit value. For receive/transmit power that is less than 0.000, an snmp query returns the corresponding dbm value even though the CLI displays as 0.000. NOTE: After the counters are cleared, the line-rate continues to increase until it reaches the maximum line rate. When the maximum line rate is reached, there is no change in the line-rate. User Information The following table describes the show interfaces command shown in the 10G example. Line Description TenGigabitEthern Interface type and administrative and line protocol status. et 1/1... Hardware is... Interface hardware information, assigned MAC address, and current address. Pluggable media present... Present pluggable media wavelength, type, and rate. The error scenarios are: • Wavelength, Non-qualified - Dell ID is not present, but wavelength information is available from XFP or SFP serial data • Wavelength, F10 unknown - Dell ID is present, but not able to determine the optics type • Unknown, Non-qualified - if wavelength is reading error, and F10 ID is not present Dell Networking allows unsupported SFP and XFP transceivers to be used, but Dell Networking OS might not be able to retrieve some data about them. In that case, typically when the output of this field is "Pluggable media present, Media type is unknown", the Medium and the XFP/SFP receive power reading data might not be present in the output. Interface index... Displays the interface index number the SNMP uses to identify the interface. Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned, that address is displayed. Interfaces 575