Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 998

Version 9.7(0.0) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.7.1.0 Description Introduced on the S6000-ON. Added support for the track-id on the S4810, S4820T, S6000, and Z9000. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Introduced on the E-Series. seq Configure a filter with an assigned sequence number for the redirect list. Syntax Parameters seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}[track ] }} {ip-protocol-number | protocol-type} {source mask | any | host ipaddress} {destination mask | any | host ip-address} [bit] [operator]{sourceport source-port| source-port-range start-port - end-port} {destination-port destination-port| destination-port-range start-port - end-port} To delete a filter, use the no seq sequence-number command. sequence-number Enter a number from 1 to 65535. permit Enter the keyword permit assign the sequence to the permit list. redirect Enter the keyword redirect to assign the sequence to the redirect list. ip-address Enter the keyword IP address of the forwarding router. tunnel Enter the keyword tunnel to configure the tunnel setting. tunnel-id Enter the keyword tunnel-id to redirect the traffic. track Enter the keyword track to enable the tracking. track Enter the keyword track to track object-id. ip-protocolnumber Enter the keyword ip-protocol-number then the number from 0 to 255 for the protocol identified in the IP protocol header. protocol-type Enter one of the following keywords as the protocol type: • icmp for internet control message protocol • ip for any internet protocol • tcp for transmission control protocol • udp for user datagram protocol source mask Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). any host ip-address destination bit Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) 998 Policy-based Routing (PBR)