Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 996

bit operator (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt= less than • range = inclusive range of ports (you must specify two ports for the portcommand parameter.) Defaults None Command Modes REDIRECT-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.5.1.0 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Introduced on the E-Series. redirect Configure a rule for the redirect list. Syntax redirect {ip-address | slot/port} | tunnel tunnel-id}[track ] {ipprotocol-number | protocol-type [bit]} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] To remove this filter, use one of the following: • Use the no seq sequence-number command if you know the filter's sequence number. • You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}[track ] {ip-protocol-number [bit] | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] command. 996 Policy-based Routing (PBR)