Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 929

Version 7.8.1.0 7.6.1.0 7.5.1.0 pre- 6.1.1.1 Description Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. network area Define which interfaces run OSPF and the OSPF area for those interfaces. Syntax Parameters network ip-address mask area area-id To disable an OSPF area, use the no network ip-address mask area area-id command. ip-address mask area-id Specify a primary or secondary address in dotted decimal format. The primary address is required before adding the secondary address. Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range is from 0 to 65535. IP address format is dotted decimal format A.B.C.D. NOTE: If the area ID is smaller than 65535, it is converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it is converted to 1. Command Modes ROUTER OSPF Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 pre- 6.1.1.1 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced to all platforms. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To enable OSPF on an interface, the network area command must include, in its range of addresses, the primary IP address of an interface. NOTE: An interface can be attached only to a single OSPF area. Open Shortest Path First (OSPFv2 and OSPFv3) 929