Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 64

Usage Information Restoring factory defaults deletes the existing startup configuration and all persistent settings (stacking, fan-out, and so forth). When restoring all units in a stack, all the units in the stack are placed into stand-alone mode. When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack are affected. When restoring units in stand-alone mode, the units remain in stand-alone mode after the restoration. After the restore is complete, the units power cycle immediately. CAUTION: There is no undo for this command. Following are the factory-default environment variables: • baudrate • primary_boot • secondary_boot • default_boot • ipaddr • gatewayip • netmask • macaddr • mgmtautoneg • mgmtspeed100 • mgmtfullduplex Each boot path variable (primary_boot, secondary_boot, and default_boot) is further split into the following three independent variables: • primary_server, primary_file, and primary_type • secondary_server, secondary_file, and secondary_type • default_server, default_file, and default_type NOTE: For information on the default values that these variables take, refer to the Restoring Factory Default Environment Variables section in the Dell Networking OS Configuration guide. Example (all stack units) Dell# restore factory-defaults stack-unit all clear-all * Warning - Restoring factory defaults will delete the existing * * startup-config and all persistent settings (stacking, fanout, etc.)* * All the units in the stack will be split into standalone units. * * After restoration the unit(s) will be powercycled immediately. * * Proceed with caution ! * Proceed with factory settings? Confirm [yes/no]:yes -- Restore status -- Unit Nvram Config 1 Success Success 2 Success Success 3 Success Success 4 Not present 5 Not present Power-cycling the unit(s). Dell# Example (single stack) Dell# restore factory-defaults stack-unit 1 clear-all Warning - Restoring factory defaults will delete the existing * * startup-config and all persistent settings (stacking, fanout, etc.)* * After restoration the unit(s) will be powercycled immediately. * * Proceed with caution Proceed with factory settings? Confirm [yes/no]:yes -- Restore status -Unit Nvram Config 64 File Management