Dell S3100 Command Line Reference Guide for the Series 9.100.0 - Page 188

Example Related Commands The number of entries allowed per ACL is hardware-dependent. For detailed specifications on entries allowed per ACL, refer to your line card documentation. Dell(conf)# ip access-list standard TestList Dell(config-std-nacl)# • ip access-list extended - create an extended access list. • show config - display the current configuration. permit To permit packets from a specific source IP address to leave the switch, configure a filter. Syntax permit {source [mask]| any | host ip-address} [no-drop] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {source [mask] | any | host ip-address} command. Parameters source mask any Enter the IP address in dotted decimal format of the network from which the packet was sent. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. You can enter any of the following keywords to specify route types. • bytes - Enter the keyword bytes to count bytes processed by the filter. • count - Enter the keyword count to count packets the filter processes. • dscp - Enter the keyword dcsp to match to the IP DCSCP values. • fragments - Enter the keyword fragments to match to non-initial fragments of a datagram. • order - Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). host ip-address no-drop Enter the keyword host then the IP address to specify a host IP address or hostname. Enter the keywords no-drop to match only the forwarded packets. Defaults Not configured. Command Modes CONFIGURATION-STANDARD-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.8(0.0) 9.7(0.0) 9.2(1.0) 9.0.2.0 Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Added the no-drop parameter. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. 188 Access Control Lists (ACL)