Epson ActionPrinter 4000 User Manual - Page 131
Testing the Printer in the Cut Sheet Feeder Mode
View all Epson ActionPrinter 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
The Cut Sheet Feeder Testing the Printer in the Cut Sheet Feeder Mode When you perform the cut sheet feeder self test, the printer counts the number of lines on the page. As shown on the following page, the number of lines counted is printed out at the bottom of the first test page. This number is the default page-length setting. This setting, however, can be overridden by software commands. Running the self test is the same as when the cut sheet feeder mode is off. The steps below are for a self test in draft mode. 1. Make sure that the printer is turned off and a stack of paper is in the bin. Check that the cut sheet feeder mode is selected and the paper release lever is pushed to the rear. 2. While holding down the LINE FEED button, turn on the printer. (For LQ mode, press the FORM FEED button instead of the LINE FEED button.) Using the Printer Options 5-9