Epson ActionPrinter 4000 User Manual - Page 197

Paper Handling Problem Switching between single sheets and continuous paper cannot be performed properly (continued). Even with the paper release lever set correctly to the singlesheet position, the single sheet and continuous paper feed together and jam. The short tear-off function does not operate properly. One page is completely printed, but the paper does not feed. Printing ended in the middle of a page. Solution The continuous paper may not have fed backward far enough to reach the standby position before you changed the position of the paper release lever. Remove the jammed paper and try again. Also, check that the PAPER OUT light comes on before changing the position of the paper release lever to make sure that the continuous paper is completely ejected. When there is more than one page to feed backward to eject, you must press the LOAD/EJECT button at least two times. DIP switch 2-2, short tear-off mode, may be set to off. Set DIP switch 2-2 to on to turn on the short tear-off mode. One page of data may not have been sent to the printer. Finish the page by sending a form feed code (FF) to the printer or by sending enough line feed codes (LF) to advance the remainder of the page. Troubleshooting 7-23