Epson ActionPrinter 4000 User Manual - Page 189

Paper Handling Problem Single sheets do not feed properly (continued). The LOAD/EJECT button was pressed and the platen rotated, but paper was not fed. When the LOAD/EJECT button is pressed, the paper jams. Solution The paper release lever may be set in the wrong position. Push paper release lever back to the single-sheet position. See Chapter 2. The left and right edge guides may be too close together, preventing the paper from feeding smoothly. Adjust the position of the edge guides so that the paper can move up and down freely. See Chapter 2. The paper may not be firmly inserted. When feeding thicker than normal paper, press down lightly on the paper while pressing the LOAD/EJECT button. The cut sheet feeder mode may be turned on (DIP switch 1-8 is on). When the cut sheet feeder is not in use, DIP switch 1-8 should be off. See Chapter 3. The edge guides may be too far apart. Adjust the edge guides to the width of the paper. The dimensions of the paper may exceed the specified limitations. Use only paper sizes that are within the specified range. Multi-part forms cannot be used with this printer's single-sheet feeding system. See Chapter 8. Troubleshooting 7-15