HP 4700n HP Color LaserJet 4700 - User Guide - Page 224
Tray Xx Size= <size>, In Job To Staple
UPC - 829160845630
View all HP 4700n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
Control panel message STAPLER LOW ON STAPLES TOO MANY PAGES IN JOB TO STAPLE Transfer unit can be easily damaged. alternates with For help press The supplies gauge will display the consumption levels of print cartridges. TRAY X EMPTY [TYPE] [SIZE] alternates with Ready TRAY X OPEN For help press alternates with Ready TRAY XX SIZE= Setting saved TYPE MISMATCH TRAY XX=[TYPE] For help press alternates with Ready Unable to mopy job alternates with Processing... Description Recommended action Fewer than 20 usable staples remain in the stapler cartridge. The status light is solid green. Order and install a new stapler cartridge. For information about replacing the stapler cartridge, see Replacing the stapler cartridge. The job contains more than the specified number of sheets for the media type being used, and cannot be stapled. When the maximum number of sheets for a specific media type is reached, the job is ejected and handled as a stacked job. To ensure that documents are properly stapled, ensure that the job does not exceed the specified number of sheets for the selected media. The cartridge is either not installed or not correctly installed in the printer. 1. Open the top and front covers. CAUTION The image transfer unit can be easily damaged. 2. Open the image transfer unit. 3. Insert the print cartridge and make sure that it is fully seated. 4. Close the image transfer unit and then close the top and front covers. 5. If the error persists, contact HP support at http://www.hp.com/support/clj4700. The specified tray is empty and the current Refill the tray at a convenient time. job does not need this tray to print. The specified tray is open or not closed completely. Close the tray. The size selected from the menu has been No action is necessary. saved. The media type loaded in the tray does not 1. Adjust the side and rear guides against match the media type configured for the tray. the paper. 2. If necessary, press after the tray is closed to change the paper size or type to match the paper loaded in the tray. The print job cannot be mopied because of a Install additional memory in the printer or memory, disk, or configuration problem. Only install a disk drive in the printer. one copy will be produced. 208 Chapter 8 Problem solving ENWW