HP DL120 ProLiant DL120 Generation 5 Server Maintenance and Service Guide - Page 51
To install the heat sink, Insert the heat sink's spring-loaded screws into the system board holes
UPC - 884962061909
View all HP DL120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
3. Rotate the load lever to the lock position. To install the heat sink: CAUTION: To prevent overheating or a possible system crash, use only a heat sink specified for your ProLiant server. 1. If you are using a new heat sink, remove the cover protecting the preapplied thermal compound. Be careful not to touch or scratch the thermal compound. 2. Install the heat sink. a. Insert the heat sink's spring-loaded screws into the system board holes (1). b. Use the system screwdriver to tighten the spring-loaded screws (2). 3. Reinstall the air baffle. 4. Perform the post-installation procedure. Removal and replacement procedures 51
Removal and replacement procedures
51
3.
Rotate the load lever to the lock position.
To install the heat sink:
CAUTION:
To prevent overheating or a possible system crash, use only a heat sink specified for
your ProLiant server.
1.
If you are using a new heat sink, remove the cover protecting the preapplied thermal compound.
Be careful not to touch or scratch the thermal compound.
2.
Install the heat sink.
a.
Insert the heat sink’s spring-loaded screws into the system board holes (
1
).
b.
Use the system screwdriver to tighten the spring-loaded screws (
2
).
3.
Reinstall the air baffle.
4.
Perform the post-installation procedure.