HP DL120 ProLiant DL120 Generation 5 Server Maintenance and Service Guide - Page 70
To replace the power supply unit, Unlatch the drive power cables from the front chassis cable tie
UPC - 884962061909
View all HP DL120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
To replace the power supply unit: 1. Perform the pre-installation procedure. 2. Disconnect the system power cables. a. Disconnect all power cables connected to the system drives (1). b. Unlatch the drive power cables from the front chassis cable tie, and then pull them through the center wall (2). c. Disconnect the system board's (PWR_CN) and processor's (CN4) ATX power cables from their system board connectors (3). d. Unlatch the ATX power cables from their chassis cable tie (4). Removal and replacement procedures 70
Removal and replacement procedures
70
To replace the power supply unit:
1.
Perform the pre-installation procedure.
2.
Disconnect the system power cables.
a.
Disconnect all power cables connected to the system drives (
1
).
b.
Unlatch the drive power cables from the front chassis cable tie, and then pull them through
the center wall (
2
).
c.
Disconnect the system board’s (PWR_CN) and processor’s (CN4) ATX power cables from
their system board connectors (
3
).
d.
Unlatch the ATX power cables from their chassis cable tie (
4
).