HP DL120 ProLiant DL120 Generation 5 Server Maintenance and Service Guide - Page 68
To replace a system fan, Install the new system fan.
UPC - 884962061909
View all HP DL120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
To replace a system fan: 1. Perform the pre-installation procedure. 2. Remove the defective system fan: a. Disconnect the fan cable from its system board connector (1). b. Unlatch the fan cable from the chassis cable clip (2). c. Grasp the fan by the blue handle, and lift it up from the chassis (3). 3. Remove the system fan from its protective packaging. 4. Install the new system fan. a. Route the fan cable through the vacated fan bracket (1). b. Insert the fan in the fan bracket (2). c. Secure the fan cable in the chassis clip (3). d. Connect the fan cable to its corresponding board connector (4). 5. Perform the post-installation procedure. Removal and replacement procedures 68
Removal and replacement procedures
68
To replace a system fan:
1.
Perform the pre-installation procedure.
2.
Remove the defective system fan:
a.
Disconnect the fan cable from its system board connector (
1
).
b.
Unlatch the fan cable from the chassis cable clip (
2
).
c.
Grasp the fan by the blue handle, and lift it up from the chassis (
3
).
3.
Remove the system fan from its protective packaging.
4.
Install the new system fan.
a.
Route the fan cable through the vacated fan bracket (
1
).
b.
Insert the fan in the fan bracket (
2
).
c.
Secure the fan cable in the chassis clip (
3
).
d.
Connect the fan cable to its corresponding board connector (
4
).
5.
Perform the post-installation procedure.