HP DL120 ProLiant DL120 Generation 5 Server Maintenance and Service Guide - Page 80
Boot menu, To remove the supervisor password
![]() |
UPC - 884962061909
View all HP DL120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
To remove the supervisor password: 1. In the Security menu screen, select the Supervisor Password Is field, and then press Enter. 2. Type the original password then press Enter. 3. Press Enter twice without entering anything in the new and confirm password fields. 4. Press F10 to save the changes you made and close the Setup Utility. The Supervisor Password Is field value is set to Clear. To reset the supervisor password: If you forget the supervisor password, you need to clear the CMOS and reset the BIOS settings to regain access the Setup Utility. For instructions, refer to the "Clearing CMOS" section on page 84. Boot menu Use this menu to set the preferred drive sequence in which the Setup Utility attempts to boot the operating system. By default, the server searches for boot devices in the following order: • CD-ROM/DVD-ROM drive • Removable device • Hard drive • Embedded NIC (via Preboot Execution Environment-remote boot over LAN) To implement the PXE boot option, you need to first set the Embedded NIC1 PXE field to Enabled. Diagnostic tools 80
![](/manual_guide/products/hewlettpackard-dl120-proliant-dl120-generation-5-server-maintenance-service-guide-27dbcac/80.png)