HP LaserJet M9040/M9050 HP LaserJet M9040/M9050 MFP - Software Technical Refer - Page 189
Output Protocol, Send Ctrl-D Before Each Job, Convert Gray Text to PostScript Gray, ASCII, Binary
View all HP LaserJet M9040/M9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Output Protocol This control specifies the protocol that the product uses for print jobs. The following options are available: ● ASCII (default) ● TBCP ● Binary Click ASCII to send data in ASCII format (7-bit), which might take longer to print but can be sent through any I/O channel, such as a serial or network port. Click TBCP (Tagged Binary Communications Protocol) to send all data except special control characters in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster than sending data in ASCII format. Click Binary to send all data except special control characters in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster than sending data in ASCII format. Send Ctrl-D Before Each Job This control specifies whether the product is reset at the beginning of every postscript document. The default setting is No. Pressing Ctrl-D resets the product to its default setting to ensure that previous print jobs do not affect the current print job. Using Ctrl-D might cause a print job to fail if the product is connected through a network. If the document fails to print when sent to a product connected through serial ports, change this setting from No to Yes. Send Ctrl-D After Each Job This control specifies whether the product is reset at the end of every postscript document. The default setting is Yes. Pressing Ctrl-D resets the product to its default setting to ensure that future print jobs are not affected by the current print job. Using Ctrl-D might cause a print job to fail if the product is connected through a network. If the document fails to print when sent to a network product, change this setting from Yes to No. Convert Gray Text to PostScript Gray This control specifies whether to convert the true gray value (RGB) in text to the gray that the driver provides. The following settings are available: ● Yes ● No (This is the default setting.) Convert Gray Graphics to PostScript Gray This control specifies whether to convert the true gray value (RGB) in graphics to the gray provided by the driver. The following settings are available: ● Yes ● No (This is the default setting.) HP PCL 5, PCL 6, and PS emulation drivers for Windows ENWW Device Settings tab features 171