HP LaserJet Pro CP1525 Service Manual - Page 109
Magenta Very Low
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Control panel message Magenta Very Low Status alert Manual duplex Load tray # Press [OK] Manual feed Press [OK] for available media Memory is low Press [OK] Misprint Press [OK] Non HP supply installed Print failure Press [OK] If error repeats turn off then on Description Recommended action The print cartridge is at the end of its useful life, and the At Very Low menu item in the System Setup menu is set to Continue. To ensure optimal print quality, HP recommends replacing the print cartridge at this point. You can continue printing until you notice a decrease in print quality. Actual cartridge life may vary. Once an HP supply has reached "very low", HP's premium Protection Warranty on that supply has ended. All print defects or cartridge failures incurred when an HP supply is used in continue at very low mode will not be considered to be defects in materials or workmanship in the supply under the HP Print Cartridge Warranty Statement. The first side of a manual duplex job has printed, and the page needs to be loaded to process the second side. Load the page in the indicated tray with the side to be printed face up, and the top of the page away from you, and then press the OK button. The product is set for manual feed mode. Press the OK button to clear the message or load the correct paper into Tray 1. The product memory is almost full. Press the OK button to finish the job, or press theCancel button to cancel the job. Paper has been delayed as it moves through the product. Break the job into smaller jobs that contain fewer pages. Press the OK button to clear the message. A non-HP supply is installed. If you believe you purchased an HP supply, go to www.hp.com/ go/anticounterfeit. Service or repairs that are required as a result of using non-HP supplies are not covered under HP warranty. The product cannot process the page. Press the OK button to continue printing the job, but output might be affected. If the error persists, turn the power off and then on. Resend the print job. ENWW Tools for troubleshooting 91