HP LaserJet Pro CP1525 Service Manual - Page 65
Power supply (low-voltage), CAUTION,
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Power supply (low-voltage) CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA. 1. Remove the following components: ● Right cover. See Right cover on page 10. ● Left cover. See Left cover on page 13. ● Rear-side cover. See Rear-side cover on page 21. ● Rear door and rear-lower cover. See Rear door and rear-lower cover on page 23. 2. Remove two screws (callout 1) and the power-supply cover (callout 2). Figure 1-70 Remove the power supply (low-voltage; 1 of 10) 2 1 ENWW Removal and replacement procedures 47