HP LaserJet Pro CP1525 Service Manual - Page 70
product chassis
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
11. Rotate the end of the power supply near the control-panel module out and away from the product until it clears the chassis, and then slide the power supply toward the control-panel module to remove it. NOTE: As you remove the power supply, feed the wire harness at the rear of the product through the opening in the chassis. TIP: Make sure that the tab on the right end of the power-supply chassis fits into the slot on the product chassis, and the left-hand side of the tray rides on top of the ledge of the chassis, when the power supply is reinstalled. Figure 1-79 Remove the power supply (low-voltage; 10 of 10) 2 1 52 Chapter 1 Removal and replacement ENWW
11.
Rotate the end of the power supply near the control-panel module out and away from the
product until it clears the chassis, and then slide the power supply toward the control-panel
module to remove it.
NOTE:
As you remove the power supply, feed the wire harness at the rear of the product
through the opening in the chassis.
TIP:
Make sure that the tab on the right end of the power-supply chassis fits into the slot on the
product chassis, and the left-hand side of the tray rides on top of the ledge of the chassis, when
the power supply is reinstalled.
Figure 1-79
Remove the power supply (low-voltage; 10 of 10)
2
1
52
Chapter 1
Removal and replacement
ENWW