HP LaserJet Pro CP1525 Service Manual - Page 37
Control-panel module, CAUTION,
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Control-panel module CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA. 1. Remove the right cover. See Right cover on page 10. 2. Open the front door. 3. Disconnect one FFC (callout 1), one wire-harness connector (callout 2), and then remove one screw (callout 3). Figure 1-27 Remove the control-panel module (1 of 3) 1 3 2 TIP: The control-panel mounting screw (callout 3) is a self-tapping screw. When reinstalling the control-panel module, make sure that you replace this screw in the correct position in the product. 4. Use a small flatblade screwdriver to release one tab (callout 4). Figure 1-28 Remove the control-panel module (2 of 3) 4 ENWW Removal and replacement procedures 19