HP LaserJet Pro CP1525 Service Manual - Page 67
When you reinstall the formatter PCA, make sure that all of the connectors on the PCA
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
5. Disconnect two wire-harness connectors (callout 7; J102 and J103). Figure 1-73 Remove the power supply (low-voltage; 4 of 10) 7 6. Disconnect one connector (callout 8; P4), and then remove four screws (callout 9) to release the formatter PCA from the chassis. NOTE: You do not need to remove the PCA. Instead, release it from the chassis so it can be moved out of the way. TIP: When you reinstall the formatter PCA, make sure that all of the connectors on the PCA are fully seated. Figure 1-74 Remove the power supply (low-voltage; 5 of 10) 9 8 ENWW Removal and replacement procedures 49
5.
Disconnect two wire-harness connectors (callout 7; J102 and J103).
Figure 1-73
Remove the power supply (low-voltage; 4 of 10)
7
6.
Disconnect one connector (callout 8; P4), and then remove four screws (callout 9) to release the
formatter PCA from the chassis.
NOTE:
You do not need to remove the PCA. Instead, release it from the chassis so it can be
moved out of the way.
TIP:
When you reinstall the formatter PCA, make sure that all of the connectors on the PCA
are fully seated.
Figure 1-74
Remove the power supply (low-voltage; 5 of 10)
9
8
ENWW
Removal and replacement procedures
49