HP LaserJet Pro CP1525 Service Manual - Page 61
Power supply (high-voltage), CAUTION,
View all HP LaserJet Pro CP1525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Power supply (high-voltage) CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA. 1. Remove the following components: ● Right cover. See Right cover on page 10. ● Left cover. See Left cover on page 13. ● Control-panel module. See Control-panel module on page 19. ● Rear-side cover. See Rear-side cover on page 21. ● Rear-upper cover. See Rear-upper cover on page 22. ● Top cover. See Top cover on page 25. 2. Disconnect one FFC (callout 1; J107) on the DC controller. Figure 1-63 Remove the power supply (high-voltage; 1 of 6) 1 ENWW Removal and replacement procedures 43