HP NetServer LP 2000r HP Netserver Ultra3 SCSI HBA Guide - Page 62
adpt160m.ham Command Line Options
View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
adpt160m.ham Command Line Options Option auto_disable_tagq= dev_enable= flush_diskreq= instr= lun_enable=a max_tags= Values on, off 0-FFFF 0-FFFF on, off 0-FF 1-128 Default off FFFF 0 off 01 16 Description Enables/disables auto disable tagged queuing algorithm. Allows you to enable the driver's registration of SCSI devices on a per target basis. By default, all targets are scanned. A bit value of 0 causes the target not to register under the operating system. These devices are still accessible via ASPI. This enable bit mask is entered in hex (see "Bit Mask Options" on page 58). A bit mask to send occasionally ordered tags to specific targets. By default, no targets receive occasionally ordered tags. This bit mask is entered in hex (see "Bit Mask Options" on page 58). Enables/disables recording of I/O statistics. A bit mask to enable scanning for specific LUNs on all targets. The default value of 01 causes the driver to scan LUN 0 only. This enable bit mask is entered in hex (see "Bit Mask Options" on page 58.) Specifies maximum number of tagged commands per device. 56