HP P4000 HP Smart Array SAS controllers for Integrity servers support guide - Page 122
Slot z Drive Array - Valid Data Found in Array, Slot z Drive Array - Data in Array Accelerator
View all HP P4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Table C-1 Smart Array controller POST error codes (continued) Error code 1786 Description Level Slot z Drive Array Recovery Needed. Informational The following disk drive(s) need Automatic Data Recovery (Rebuild): Port 1I: Box 2: Bay 5 Select "F1" to continue with recovery of data to drive(s). Select "F2" to continue without recovery of data to drive(s). OR Slot 1 Drive Array Recovery Needed The following disk drive(s) need Automatic Data Recovery (Rebuild): Port 2I: Box 1: Bay 4 Automatic Data Recovery previously Aborted! Select "F1" to retry Automatic Data Recovery. Select "F2" to continue without starting Automatic Data Recovery. Corrective action Follow the instructions in the error message to correct the error condition. 1787 Slot z Drive Array Operating in Interim Recovery Informational Mode. The following disk drive(s) should be replaced: Port 1I: Box 3: Bay 1 Replace the indicated disk. 1788 Slot z Drive Array Reports Incorrect Drive Informational Replacement. The following disk drive(s) should have been replaced: Port 1I: Box 2: Bay 1 The following SCSI drive(s) were incorrectly replaced: Port 2I: Box 1: Bay 3 Press F1 to continue. The drive array remains disabled. Press F2 to reset configuration - all data will be lost. Warning: Pressing F2 erases all data in the array. Be sure you have a valid, current backup of the affected logical drives before selecting this option. 1789 Slot z Drive Array Physical Drive(s) Not Responding. Check cables or replace the following physical drive(s): Port 1I: Box 1: Bay 8 Informational Press F1 to continue. The drive array remains disabled. Press F2 to fail drives that are not responding. Interim Recovery Mode is enabled if configured for fault tolerance. 1792 1793 Slot z Drive Array - Valid Data Found in Array None Accelerator. Data will automatically be written to drive array. Slot z Drive Array - Data in Array Accelerator has been Lost Array Accelerator Battery Depleted (Error message 1794 will also be displayed.) Critical None. The cache battery was depleted before the system was returned to a state where the cached data could be written to the array. Data loss may occur. 122 Power-on Self Test (POST) error codes