HP PSC 1600 HP PSC 1600 All-in-One series User Guide - Page 90
Change the device settings, Set the scroll speed
View all HP PSC 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
To clean the area around the ink nozzles 1. Turn on the HP All-in-One and open the print-carriage access door. The print carriage moves to the far right side of the HP All-in-One. 2. Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the HP All-in-One. 3. Lightly press down on the print cartridge to release it, and then pull it toward you out of the slot. Note Do not remove both print cartridges at the same time. Remove and clean each print cartridge one at a time. Do not leave a print cartridge outside the HP All-in-One for more than 30 minutes. 4. Place the print cartridge on a piece of paper with the ink nozzles facing up. 5. Lightly moisten a clean foam rubber swab with distilled water. 6. Clean the face and edges around the ink nozzle area with the swab, as shown below. Maintain your HP All-in-One 1 Nozzle plate (do not clean) 2 Face and edges around the ink nozzle area Warning Do not clean the nozzle plate. 7. Allow the ink nozzle area to dry for approximately ten minutes. 8. Slide the print cartridge back into the slot. Push the print cartridge forward until it clicks into place. 9. Repeat if necessary for the other print cartridge. 10. Gently close the print-carriage access door and plug the power cord into the back of the HP All-in-One. Change the device settings You can change the scroll speed and prompt delay time settings on your HP All-inOne so that it behaves according to your preference. You can also restore the device settings to what they were when you purchased your device. This will erase any new defaults you have set. Set the scroll speed The Scroll Speed option lets you control the rate that text messages scroll in the control panel display. For example, if the message is "Load paper, then press OK.", User Guide 87