HP StorageWorks 300 HP StorageWorks 300 Virtual Library System user guide (AH1 - Page 133
Power supply, Ejecting the CD-ROM drive, Removing a node power supply
View all HP StorageWorks 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
NOTE: The ejector button for the CD-ROM drive is recessed to prevent accidental ejection; it may be helpful to use a small, blunt object, such as a pen, to push the ejector button. 2. Press the ejector button in firmly until the CD-ROM drive ejects (1). 3. Pull the CD-ROM drive out of the node. 1 2 Figure 74 Ejecting the CD-ROM drive To replace the component: 1. Carefully align the connector on the rear of the drive with the connector on the CD-ROM/diskette drive interface board. 2. Slide the drive into the bay until it clicks. Power supply CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless all bays are populated with either a component or a blank. 1. Disconnect the power cord from the power supply. 2. Press the power supply release lever (1), and then pull the power supply from the node. 1 2 Figure 75 Removing a node power supply To replace the component: HP StorageWorks 133