HP StorageWorks 300 HP StorageWorks 300 Virtual Library System user guide (AH1 - Page 26
Attach rails to the VLS300 appliance, Install rails, Remove slides from rails
View all HP StorageWorks 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
5201b Figure 1 Install rails c. Repeat these tasks for the rail on the other side of the rack. 3. Remove the inner slide rails from the outer slide rails. To do so, extend the inner slide rails from the front of the rack until they lock in place. Then press the inner rail release latch (see Figure 2) and pull the inner slide rails straight out. Figure 2 Remove slides from rails 10685A Attach rails to the VLS300 (appliance) To attach the rails to the appliance: 1. Align the rail with the node so that the word "FRONT" on the rail is seen right-side-up and at the front of the node. 26 Hardware installation
5201b
Figure 1 Install rails
c.
Repeat these tasks for the rail on the other side of the rack.
3.
Remove the inner slide rails from the outer slide rails. To do so, extend the inner slide rails from the
front of the rack until they lock in place. Then press the inner rail release latch (see
Figure 2
) and
pull the inner slide rails straight out.
10685A
Figure 2 Remove slides from rails
Attach rails to the VLS300 (appliance)
To attach the rails to the appliance:
1.
Align the rail with the node so that the word “FRONT” on the rail is seen right-side-up and at the
front of the node.
26
Hardware installation