HP Surestore Tape Library Model 10/180 HP Surestore Bridge FC 2/1 LV and FC 4/ - Page 88
SCSI to Fibre Channel Mapping, Configuration
View all HP Surestore Tape Library Model 10/180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
SCSI Configuration Menu Version X.X XXXX Bus 1, Current SCSI Configuration: Initiator SCSI ID: 7 Target SCSI ID(s): Reset SCSI Bus on Boot: Yes SCSI Initial Discovery Delay: 2000 ms Initiator Mode Buffered Tape Writes: Enabled Target Mode Buffered Tape Writes: Disabled SCSI Termination: Internal 1) Change Initiator SCSI ID 2) Add Target SCSI ID 3) Remove Target SCSI ID 4) Toggle SCSI Reset Operation 5) Change Discovery Delay Time 6) Toggle Initiator Mode Buffered Tape Writes 7) Toggle Target Mode Buffered Tape Writes 8) Toggle SCSI Termination Mode (FC 2/1 only) X) Return to previous menu ■ Select 1) to change the initiator SCSI ID. This is the ID for the SCSI device that requests operations from other SCSI devices known as targets. This should be a unique ID on the bus, the default is 7. ■ Select 2) to add a target SCSI ID. This section is used only when the bridge is configured as a SCSI target for use with SCSI initiators. This is NOT relevant to the use of the bridge in a tape library or MO jukebox. This adds an ID for a SCSI device that responds to operation requests from the SCSI initiator. This must be setup before users can access SCSI to Fibre Channel mapping (from the SCSI to Fibre Channel Mapping Configuration menu). ■ Select 3) to remove a target SCSI ID. This section is used only when the bridge is configured as a SCSI target for use with SCSI initiators. This is NOT relevant to the use of the bridge in a tape library or MO jukebox. This option eliminates target IDs previously added. 90 Perform Configuration Chapter 4