Honeywell HPF24S8 Installation Instructions - Page 23
AC Fail Delay/Aux. Trouble Relay Function, Input/Output Function
View all Honeywell HPF24S8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Programmable Features Description Programming Options Important! In Slave Mode, if the Input is active, but no signal is present on the Sync Input circuit, the power supply will turn the NACs on steady until a sync signal appears. The NACs will turn off when the Input becomes inactive. Also in Slave Mode, if the Input is active and the Sync Input is suddenly lost (HPF24S or wiring failure), there will be a three second period in which the NAC outputs are indeterminate. After this three second period, the power supply will turn the NACs on steady until the Input becomes inactive. 3.2.3 AC Fail Delay/Aux. Trouble Relay Function The AC Fail Delay feature provides the option to delay generation of a trouble signal upon the loss of AC power. In addition, the operation of the Aux. Trouble Relay is altered. • DIP switch 4 set to the ON position will delay the generation of an AC Loss/brownout trouble signal for 2 hours. In addition, the Aux. Trouble Relay will immediately respond to all trouble conditions on the power supply. • DIP switch 4 set to the OFF position will allow the HPF24S to generate a trouble signal immediately on the loss of AC power. In addition, the Aux. Trouble Relay will respond only to AC power fail/brownout conditions. Refer to Section 4.1.2, "Supervision of HPF24S Faults", on page 25 for operation of internal NAC trouble relay in response to AC loss. 3.2.4 Input/Output Function DIP switches 5 and 6 are used to determine the Input Control circuits that will activate the four output circuits and the function of the output circuits. For example, to configure a General Alarm operation in which Input Control Circuit #1 activates all four output NACs, DIP switches 5 and 6 are both set to the OFF position. In this configuration, the Sync Input circuit is ignored if the power supply is set as a Master but will be monitored if the supply is set as a Slave. In addition, if the Auxiliary Power output is set as a resettable output, the circuit connected to Control Input Circuit #2 will control the auxiliary power reset function. HPF24S Series Power Supplies - P/N 52751:D3 5/11/2010 23