IBM 7945E2U User Manual - Page 127
Attention, Important, DIMM, and then reinsert it.
View all IBM 7945E2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently. 6. Open the retaining clip on each end of the DIMM connector. 7. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the server. Then, remove the DIMM from the package. 8. Turn the DIMM so that the DIMM keys align correctly with the connector. 9. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector. Important: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it. 10. Install the DIMM air baffle (see "Installing the DIMM air baffle" on page 50). 11. Install PCI riser-card assembly 2, if you removed it (see "Installing a PCI riser-card assembly" on page 46). If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on page 139. Go to the Setup utility and make sure all the installed DIMMs are present and enabled. Chapter 2. Installing optional devices 111