IBM 7945E2U User Manual - Page 88
Make sure that the configuration cable is connected to all backplanes.
View all IBM 7945E2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
b. Reconnect the power cable 2 to backplane 1. c. Reconnect the configuration cable 3 to backplane 1. d. Angle the backplane and place the bottom edge into the slots for backplane 1 on the chassis. e. Rotate the backplane upright so that the bracket goes underneath the latch and tabs on the chassis and is engaged into the slots on the backplane bracket. 14. Make sure that the configuration cable is connected to all backplanes. 15. Remove the rear controller retention bracket located in the battery bay above the power supplies by pulling up the release tab 1 and sliding the bracket outward 2 . 16. Install the SAS controller front retention bracket that you got from step 15: 72 System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide