IBM 7945E2U User Manual - Page 62
Installing a PCI riser-card assembly
![]() |
View all IBM 7945E2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Installing a PCI riser-card assembly To install a PCI riser-card assembly, complete the following steps. Note: The illustrations in this document might differ slightly from your hardware. PCI riser-card assembly 2 PCI riser-card assembly 1 PCI riser connector 2 Alignment slots Alignment brackets PCI riser connector 1 1. Read the safety information that begins on page vii and "Installation guidelines" on page 37. 2. Make sure that the server and all peripheral devices are turned off and that the power cords and all external cables are disconnected. 3. Reinstall any adapters and reconnect any internal cables that you removed in other procedures. 4. Align the PCI riser-card assembly with the selected PCI riser-card connector on the system board: v PCI riser-card connector 1: Carefully fit the two alignment slots on the side of the assembly onto the two alignment brackets in the side of the chassis. v PCI riser-card connector 2: Carefully align the bottom edge (the contact edge) of the riser-card assembly with the PCI riser-card connector on the system board. 5. Press down on the assembly. Make sure that the riser-card assembly is fully seated in the riser-card connector on the system board. If you have other devices to install, do so now. Otherwise, go to "Completing the installation" on page 139. 46 System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
![](/manual_guide/products/ibm-7945b2u-user-manual-ae785ae/62.png)