IBM 7945E2U User Manual - Page 99
disk drive backplane 2, Connect the new power cable that comes with the option kit to new hard
View all IBM 7945E2U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
b. Lift backplane 1 out of the server by pulling it toward the rear of the server and then lifting it up. 12. Install the new backplane in slot 2: a. Move the SAS signal cable from hard disk drive backplane 1 to new backplane 2 1 . The new backplane comes with the option kit. b. Connect the new power cable that comes with the option kit to new hard disk drive backplane 2 2 . c. Connect the configuration cable to backplane 2 3 . d. Angle the new backplane and place the bottom edge into the slots for backplane 2 on the chassis next to the optical drive. Chapter 2. Installing optional devices 83
b.
Lift backplane 1 out of the server by pulling it toward the rear of the server
and then lifting it up.
12.
Install the new backplane in slot 2:
a.
Move the SAS signal cable from hard disk drive backplane 1 to new
backplane 2
±1²
. The new backplane comes with the option kit.
b.
Connect the new power cable that comes with the option kit to new hard
disk drive backplane 2
±2²
.
c.
Connect the configuration cable to backplane 2
±3²
.
d.
Angle the new backplane and place the bottom edge into the slots for
backplane 2 on the chassis next to the optical drive.
Chapter 2. Installing optional devices
83