IBM DJSA-210 Hard Drive Specifications - Page 102
Protected Area Function, 9.1 Example for operation In LBA Mode
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
11.9 Protected Area Function Protected Area Function is to provide the 'protected area' which cannot be accessed via conventional methods. This 'protected area' is used to contain critical system data such as BIOS or system management information. The contents of the entire system main memory may also be dumped into the 'protected area' to resume after a system power off. The LBA/CYL changed by the following commands affects the Identify Device Information. Two commands are defined for this function. Read Native Max ADDRESS ('F8'h) Set Max ADDRESS ('F9'h) Four security extension commands are implemented as subfunctions of the Set Max ADDRESS. Set Max UNLOCK Set Max FREEZE LOCK Set Max LOCK Set Max SET PASSWORD 11.9.1 Example for operation (In LBA Mode) Assumptions : For easier understanding the following example uses actual values for LBA, size, etc. Since it is an example, these values will differ. Device characteristics Capacity (native) Max LBA (native) Required size for protected area Required blocks for protected area Customer usable device size Customer usable sector count LBA range for protected area 536,870,912 byte (536MB) 1,048,575 (0FFFFFh) 8,388,608 byte 16,384 (004000h) 528,482,304 byte (528MB) 1,032,192 (0FC000h) 0FC000h to 0FFFFFh 1. Shipping HDDs from the HDD manufacturer When the HDD is shipped from the manufacturer, the device has been tested to have a capacity of 536 MB, flagging the media defects not visible by the system. 2. Preparing HDDs at system manufacturer Special utility software is required to define the size of the protected area and store the data in it. The sequence is: Issue Read Native Max ADDRESS command to get the real device max. of LBA/CYL. Returned value shows that native device Max LBA is 0FFFFFh regardless of the current setting. Make entire device accessible, including the protected area, by setting the device Max LBA as 0FFFFFh via Set Max ADDRESS command. The option could be either nonvolatile or volatile. Travelstar 32GH/30GT/20GN hard disk drive specifications 88