IBM DJSA-210 Hard Drive Specifications - Page 46
Connector and jumper description, 5.4 Mounting orientation - travelstar jumper settings
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Figure 25. Mounting hole locations of the DJSA-232/230 6.5.3 Connector and jumper description A jumper is used to designate the drive address as either master or slave. The jumper setting method is described in section 7.10. Connector specifications are included in Part 2 of this document-Electrical Interface specifications. 6.5.4 Mounting orientation The drive will operate in all axes (6 directions) and will stay within the specified error rates when tilted ±5 degrees from these positions. Performance and error rate will stay within specification limits if the drive is operated in the other permissible orientations from which it was formatted. Thus a drive formatted in a horizontal orientation will be able to run vertically and vice versa. The recommended mounting screw torque is 3.0±0.5 kgf-cm. The recommended mounting screw depth is 3.0±0.3 mm for bottom and 3.5±0.5 mm for horizontal mounting. Travelstar 32GH/30GT/20GN hard disk drive specifications 32