IBM DJSA-210 Hard Drive Specifications - Page 39
DC power requirements, Power Supply Ripple 0-20 MHz
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
6.2 DC power requirements Connection to the product should be made in isolated secondary circuits (SELV). The voltage specifications are applied at the power connector of the drive. Item Nominal Supply Power Supply Ripple (0-20 MHz) Tolerance Supply rise time Supply Current (+5.00 V dc case) Requirements +5 Volt dc 100 mV p-p max. ±5% 7-100 ms Population Mean (nominal condition) Notes *1 *2 Watts (RMS Typical) Performance Idle average Active Idle average Low Power Idle average Read average Write average Seek average Standby Sleep Startup (maximum peak) Average from power on to ready DJSA-232 2.0 1.3 0.9 2.5 2.7 2.6 0.25 0.1 5.0 3.8 DJSA-230 1.85 0.95 0.65 2.1 2.2 2.3 0.25 0.1 4.7 3.3 DJSA220/210/205 1.85 0.85 0.65 2.0 2.1 2.3 0.25 0.1 4.7 3.3 Notes *3 *4 *5 *6 Notes: *1. The maximum fixed disk ripple is measured at the 5 volt input of the HDD. *2. The disk drive shall not incur damage for an over voltage condition of +25% (maximum duration of 20 ms) on the 5 volt nominal supply. *3. The idle current is specified at an inner track. *4. The read/write current is specified based on three operations of 63 sector read/write per 100 ms. *5. The seek average current is specified based on three operations per 100 ms. *6. The worst case operating current includes motor surge. Figure 18. DC Power requirements Travelstar 32GH/30GT/20GN hard disk drive specifications 25