IBM DJSA-210 Hard Drive Specifications - Page 168
Note 3. When the Feature register is 85h = Disable Advanced Power Management the deepest Power
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Output Parameters To The Device Feature Destination code for this command. 02H Enable write cache (See note 2) 03H Set transfer mode based on value in sector count register 05H Enable Advanced Power Management 09H Enable Address Offset mode 44H 40 bytes of ECC apply on Read Long/Write Long commands 55H Disable read look-ahead feature 66H Disable reverting to power on defaults 82H Disable write cache 85H Disable Advanced Power Management (See note 3) 89H Disable Address Offset mode AAH Enable read look-ahead feature BBH 4 bytes of ECC apply on Read Long/Write Long commands CCH Enable reverting to power on defaults Note 1. When the Feature register is 03h ( = Set Transfer mode) the Sector Count Register specifies the transfer mechanism. The upper 5 bits define the type of transfer and the low order 3 bits encode the mode value. PIO Default Transfer Mode PIO Default Transfer Mode,Disable IORDY PIO Flow Control Transfer Mode x 00001 nnn Multiword DMA mode x 00100 nnn Ultra DMA mode x 01000 nnn 00000 000 00000 001 (nnn=000,001,010,011,100) (nnn=000,001,010) (nnn=000,001,010,011,100) When the Feature register is 05h ( = Enable Advanced Power Management) the Sector Count Register specifies the Advanced Power Management level. C0h-FEh 80h-BFh 01h-7Fh 00h, FFh The deepest Power Saving mode is Active Idle The deepest Power Saving mode is Low power Idle The deepest Power Saving mode is Standby Aborted Note 2. If the number of auto reassigned sectors reaches the device's reassignment capacity, the write cache function will be automatically disabled. Although the device still accepts the Set Features command (with Feature register = 02h) without error, the write cache function will remain disabled. For the current write cache function status, refer to the Identify Device Information (129 word) by the Identify Device command. Hard reset or power off must not be done in 5 seconds after write command completion when write cache is enabled. Note 3. When the Feature register is 85h (= Disable Advanced Power Management) the deepest Power Saving mode becomes Active Idle. Travelstar 32GH/30GT/20GN hard disk drive specifications 154